30 Series Torq A Verter Kit, Comet Aftermarket

Product Description

This 30 Series TAV Kit is a quality aftermarket reproduction of the Comet made TAV2 Torque Converter Kit. Designed to be used on go-karts, mini-bikes and wake wrenches with engine sizes 3hp to 7hp. This is a must on live axle go-karts especially those with rear tires larger than 14″ tall. A centrifugal clutch will not pull or hold up to these demands. For your convenience this kit comes with both sprockets, a #35 chain 12 tooth sprocket and the #41/40/420 chain with the #10 tooth sprocket. (This is not made by Comet)
This kit is an asymmetrical type torque converter system, which means the sheave faces are non-symmetrical. They have different angles. In this case, the movable sheave face is 18?? while the stationary sheave face is 2 1/2?? for a collective angle of 20 1/2??. Here are some reasons for selecting the asymmetrical concept: The Asymmetric concept operates on an in-line principal with the torque sensing cam in an outboard attitude. Only this system is designed to operate this way, thus providing the proper alignment for the final drive chain to be on the same side of the vehicle as the P.T.O. This offers some very significant advantages to mounting requirements in many cases. The asymmetric concept, having the 18?? angle on one side requires less sheave face travel to lift the belt to larger, comparable pitch diameters of the symmetrical system. This makes it possible to force the belt to a diameter within the drive clutch (at high RPM) that exceeds the usual 1:1 ratio of standard systems. The TAV can actually attain an .90:1 or 10% overdrive.

**DO NOT RUN WITHOUT A BELT**

Compatible 3/4″ Crankshaft Engines:
Tillotson 196/212/225cc
Predator 212 Hemi and Non Hemi
Honda GX200
196cc Clones
*Not compatible with the 16mm Crankshaft Hisun Engine on Minibikes. Please check out our TAV Kit if you do have the smaller 16mm crankshaft.
Kit Includes:
30 Series Driver 3/4″ bore – part # 5957
30 Series Driven 5/8″ bore – part # 5958
12T #35 Sprocket – part # 3504
10T #41/40/420 Sprocket – Part # 202168
Drive Belt Asymmetrical (725 BELT)
Back Plate
Plastic TAV Cover
All necessary hardware to install kit
Additional Information:
Replacement bearings for jack shaft -# 6003
We recommend #420 chain with this kit when using the 10 tooth sprocket.
We recommend you use an impact when installing these parts. Failure to do so may result in the torque converter coming apart and possible injury.
Download Spec Sheet