- Locate the Drive Belt:
- The drive belt is usually located near the engine and the rear axle of the go-kart.
- Loosen Components:
- Use the appropriate tools to loosen any components that are obstructing access to the drive belt, such as belt guards, engine shrouds, or covers.
- Release Tension:
- Depending on the design of your go-kart, you may need to release tension from the old drive belt. This could involve loosening tensioning bolts or adjusting mechanisms.
- Some go-karts have a tensioning system that can be loosened to remove the belt.
- Remove the Old Belt:
- Carefully slide the old drive belt off the pulleys and sprockets. Take note of how the belt is routed.
- Install the New Belt:
- Carefully slide the new drive belt onto the pulleys and sprockets, following the same routing as the old belt.
- Tension the New Belt:
- If your go-kart has an adjustable tensioning system, adjust it to achieve the proper belt tension. Refer to your go-kart’s manual for guidance on tensioning.
- Reassemble:
- Reattach any components you removed earlier, such as belt guards and covers.
- Make sure all fasteners are properly tightened.
- Final Checks:
- Double-check that all components are properly installed and secured.
- Ensure the new drive belt is properly aligned on the pulleys and sprockets.
how to install a drive belt on a go kart
how to change drive belt on go kart
